Tech Tips

Use this comprehensive information library whenever you need helpful hints from car repair professionals. Whether you are a professional or a DIY mechanic, you’re sure to find the tips you need to insure a job well done. Click here to go back to the previous page any time during your search.

Honda

Troubleshooting '92-'96 Prelude 2200cc, S models, Electrical System

1. Check alternator connections and drive belt tension.
2. Test battery and make sure that it is fully charged.  Inspect battery cables and alternator connection.
3. Check fuse No.2 (15A) in the dash fuse box.  Replace fuse if needed.  If fuse is blown, charge warning light will come on even if the charging system is operating properly.
4. With engine at operating temperature, stop engine, unplug alternator harness, turn key to on position without engine running. 
5. Check for battery voltage between the Black/Yellow wire and ground.
   1. If no voltage is present check passenger compartment fuse/relay box, fuse No.23, or inspect for an open in the Black/Yellow wire.
6. "Charge Warning Light" should not be on.
   1. If "Charge Warning Light" is on, check for short to ground in White/Blue wire, check for shorted integrated control unit (ICU), shorted ABS control  unit or 4WS, if your vehicle is equipped with these items.
7. Connect jumper wire between the White/Blue wire and ground.
   1. If "Charge Warning Light" comes on, circuit is goodl
   2. If "Charge Warning Light" does not come on, then check for burned bulb, open circuit in the White/Blue wire, open circuit in the Black/Yellow wire between the warning light and the dash fuse box, or between dash fuse box and ignition switch.
8. Check for battery voltage between Green/White wire and ground.
   1. If voltage is present, circuit is good.
   2. If voltage is not present, check for open in White/Green wire, faulty PGM-FI or faulty ELD (Electric Load Detector).
9. Turn ignition switch off and reconnect alternator harness.
10. Start engine.
11. Operate engine at 2000 RPM and check output voltage.
    1. If voltage is greater than 15.1 Vdc, voltage regulator is faulty.  Replace the alternator.
    2. If voltage is less than 13.5 Vdc, check the battery and/or alternator.
    3. Apply load (lights, heater, carbon pile) until voltage is between 12.0 and 13.5 volts.  Check amperage - it should be:
       1. 2.2L -- 55A or greater
       2. 2.2L VTEC -- 65A or greater
       3. 2.3L -- 60A or greater

Go back